The manufacturer of Quick Attach Tri-Glide tells you the following seven sewing methods for jacquard elastic band, let’s have a look together:

The first
1. Sew more than half of the cloth to form a cylindrical shape.
2. Open the seam allowance, and sew the edge of the cloth over half the width of an elastic band. Leave 2cm in the middle of the seam allowance for the elastic.
3. After the elastic band is inserted, the elastic band is layered and sewed. The jacquard elastic used by this girl is relatively wide, so the frame-style sewing method is used. If everyone uses a narrower one, it is enough to sew parallel lines back and forth immediately after layering. The manufacturer of Quick Attach Tri-Glide tells you that the seam method below is that the elastic band is not laminated, and the seam is directly sewed back and forth in a zigzag for a few stitches. Finally, sew the mouth where the elastic band is worn.
the second
Or first sew the cloth into a cylindrical shape, divide the cloth and elastic into two equal parts, and fix it with a needle in the middle. Sew the jacquard elastic to the edge of the fabric in a zigzag shape, then fold the elastic to the inner lining and sew a parallel line. Remember to straighten the elastic when sewing.
third
This one is similar to the second seaming method, except that a thin elastic band is used when sewing the last line, and the elastic band is gently coiled on the shuttle, which is the same as the operation method of the moral bottom thread , sew the elastic moral bottom thread to the back of the cloth. After stitching is the actual effect of the last picture.
fourth
The manufacturer of Quick Attach Tri-Glide tells you that the required cloth must be the total width of the elastic band + 2 cm seam allowance. First, the cloth is more than half, sewed, and then use a paper clip to turn the sewn tube out of the front, according to the One way is to put the elastic band in and then stitch both sides firmly is the final effect.
Fifth
Two pieces of cloth are needed, draw the width of the elastic band on the upper one, and sew the two pieces of cloth together along these two lines, insert the elastic band, and then sew the end of the cloth to complete.
sixth
First draw the trajectory of the elastic band that needs to be sewed on the cloth, and then find the middle points of the cloth and the elastic band, that is, when the cloth is divided into two equal parts, remember that the two ends of the middle point should be aligned, and immediately place them on the elastic band Just sew parallel lines.
seventh
The manufacturer of Quick Attach Tri-Glide tells you to first draw the trajectory of the elastic band to be sewn on the cloth, and immediately sew parallel lines on the cloth. The thin elastic band is just a little tighter when it is coiled on the shuttle as a bottom line.